Reloadable motor P38-5G - CTI

Pro-38 reloadable motor hardware is very easy to use. Select your reload, adjust the delay following your needs, push the reload into the casing and thread the rear closure. You do not need any additional closure because are both included in each reload. After each flight you just have to dispose of the burned reload and clean the motor. The motor can be used an indefinite number of times.

Cesaroni hardware is very easy to clean after each flight with damp cloth as the reloads do not leave many residues on the internal surface.

You can use reloads made for P38-3G and P38-4G motors by using one or two Pro38 Spacers. Please remember these casings are not compatible with Aerotech reloads.

When to use this engine?This motor uses I reload at the top end of the power for this class, and J reloads at the low end of the power for this class. This means you can use the same rocket you fly with I motors also for your Level 2 certification flight, with cheap J reloads.

The following reloads can be used with this motor (Level 1 or 2 certification required):

636I216-14A
543I297-15A
601I350-16A
634I540-16A
567I125-10A
648J285-15A
649J335-15A
654J316-17A
658J357-17A
684J290-15A
650J270-13A