Set the delay of your Aerotech reload

The Universal Delay Drilling Tool is used to shorten the delay time of Aerotech RMS-EZ reloads. By adjusting the delay time you can get the parachute ejected at the perfect flight time you calculated.

This retainer ring replaces the standard forward closure of 38 mm RMS motors when using RMS-EZ reloads

High Power 29/100 reloadable motor casing only. Does not include closures. If you already own a 29 mm High Power RMS motor, with this case you can use all the reloads kits made for it.

High Power 29/60 reloadable motor casing only. Does not include closures. If you already own a 29 mm High Power RMS motor, with this case you can use all the reloads kits made for it.

Extended forward plugged closure for Aerotech and Monster 54 mm reloadable rocket motors. It must be used with J90W, J135W, K185W, K270W Aerotech reloads, when the ejection charge is not needed.

Extended forward plugged and threaded closure for Aerotech and Monster 54 mm reloadable rocket motors. It must be used with J90W, J135W, K185W, K270W Aerotech reloads, when the ejection charge is not needed and to retain the motor through a threaded rod.

Forward plugged and threaded closure for Aerotech and Monster 54 mm reloadable rocket motors. It is used when the ejection charge is not needed and to retain the motor through a threaded rod.

Aft closure for Aerotech or Monster 75 mm reloadable motors

Forward seal disc for Aerotech/Monster 98 mm reloadable motors. This is a replacement part, the disc is normally included in any RMS 98 mm motor hardware. 

The Aerotech RMS Delay Drilling Tool is used to shorten the delay time of the RDK, HDK and HDK+ delays used in the Aerotech reloadable motors. By adjusting the delay time you can get the parachute ejected at the perfect flight time you calculated.

Forward replacement closure for Aerotech 24 mm motor RMS 24/40

Extended forward closure for Aerotech or Monster reloadable RMS 54 mm motors. Must be used with long burn reloads.