Expedition - Estes

EST7249

Large model rocket for D engines, for those who like to build complex models.

Más detalles

1 Elemento

Advertencia: ¡Últimos artículos en inventario!

35,99 €

Ficha técnica

Length65 cm
Diameter56 mm
Weight142 gr
Motor mount24 mm
Recovery46 cm plastic parachute
Launch pad5 mm
Recommended EnginesEstes: C11-3, D12-5 - Aerotech Single Use: E15-4W - Aerotech RMS: D15-4T, E11-3J, E18-4W, F12-5J

Más

The Expedition is a rocket kit that flies with D motors or other 24 mm motors. Its particular shape is obtained with a rather elaborate but exciting construction, ideal for the enthusiastic builder.

The rear part of the rocket has a false nozzle and aerodynamic fairings on each fin that are made by slicing a tube, with the help of templates included in the instructions. Also the conical transition between tubes of different diameter have to be cut and paste also the frusto-conical transitions between the two pipes of different diameter which make up the fuselage.

The model flies with 24 mm engines, like Estes C11 or D12, but it can also use Aerotech motors of the same diameter. The recovery is by a plastic parachute, included in the kit.

The kit includes detailed multilingual installation instructions.

This rocket requires a launching pad with 5mm launch rod like the Estes Porta Pad II or Estes E-Launch pad, and an electric launch controller as the Estes E-Launch Controller or Estes Electron Beam Launch Controller .

If you want to use this rocket with Aerotech motors, you will need a 12-volt launch controller as the Estes PS II Launch Controller or the Aerotech Interlock Controller.

The kit includes:

  • Every part needed to build the rocket model (tubes, rings, plastic parts, etc.)
  • Water decals
  • Pre-assembled plastic parachutes
  • Detailed instructions

To assemble the rocket you need (not included):

Hobby knife, scissors, tweezers, ruler, pencil, aliphatic glue, plastic cement, permanent spray glue, cyanoacrylate glue, masking tape, transparent adhesive tape, fine sandpaper, spray paints

To launch your rocket you need (not included):

  • 5 mm launch rod
  • Launch pad suitable for 5 mm rods
  • Launch controller
  • Engines (see Recommended engine list)
  • Wadding or protective sheets for parachutes